Touch Screen with Digitizer for HTC Wildfire S(Special Version)
Do you need a new repair part Touch Screen for your HTC Wildfire S ? This HTC replacement digitizer touch screen glass replaces your existing damaged, cracked, non responsive and old digitizer touch panel that helps restore your mobile phone back to its perfect condition.
HTC Wildfire S G13 touch screen has two versions,one is universal version,the other is special version.they can't compatible with each other,and most country of htc g13 is universal version.
- Test one by one before shipping
- Good quality
HTC Wildfire S
Note:Please read the bellow describe before you order.
When fitting please make sure a sw update and calibration is done To All Customers.
Htc as well as blackberry have different revisions and ics on digitizers as well as lcds.
On most HTC repairs when replacing the digitizer, the software needs updating. (especially on sensation, wildfire S and Mozart)
The newer models to follow will also need a sw update and calibration.
To simply enable this process we suggest you do the following:
1. hard reset or firmware/software update
2. calibration ( this can be done via the XTC CLIP/hxc dongle) - You need this clip if youre replacing touchpads on the HTC
Steps with XTC CLIP:
If you already have access to the diag file follow these simple steps
Make a gold card (plenty of tutorials, use search)
Copy diag file to goldcard
Boot to bootloader (volume down and power)
You may get an error, ignore it and press vol down to exit
Screen will have the following message
Action => flash
Vol down => diag
Press vol down for diag NOT POWER
you will quickly see a screen asking you to put phone on a flat surface for TP calibration ... do it
Once that is done, you will see a menu about clear S58 data. Ignore it as you need xtc clip for that, and the repair is already done. Simply pull the battery and reboot
Warning!!! Tested by myself on 3 (three) phones running pure stock. Not been tested with custom roms or any other modification. Doing this will also do a full factory reset on the phone.
During Calibration, hold phone upright for 5mins. This aligns everything.
(after fitting in sensation/wildifre S and other non responsive touchpads, the above process is a necessary)